Mora
Mora 151 Knife Blade, Carbon Steel
- Gift wrapping:
- Options available
Bulk discount rates
Below are the available bulk discount rates for each individual item when you purchase a certain amount
Buy 3 or above | and pay only $252.74 each |
Description
Mora 151 Knife Blade
Carbon Steel blade, polished to a near mirror finish.
Mora blades are made in Mora,Sweden, the maker has over a century of history in making these blades.
The blade is made from carbon steel of high hardness, laminated between sides of more flexible, soft steel.
This gives a very hard, sharp cutting edge (61 HRC),a strong flexible blade and allows for a thinner blade.
The blade blank is 2.5 mm thick, about 25 mm high and has about 151 mm of blade.
Total length from tip to end of tang is 265 mm, the tang can be cut to fit the handle if required.
Mora blades are well known amongst bushcrafters as good value, strong blades.
We do not carry an exact matching bolster for this blade. Eiter make a small enough hole in the handle block to get a clean fit, or may be easier to make a bolster by cutting off a section of the handle block so it can be worked from both sides until a tight fit is achieved. Then a layer of spacer material, and the rest of the handle block with a bigger tang hole.
https://nordicedge.com.au/knife-kits/