Blacksmithing Punches

Blacksmithing punches

Different punches and slitting tools for blacksmithing. Bulk pricing for 3+ items.

Note the punch tongs are $55/each, the other tools $45/each. Buying 3+ across the range takes off $6/each item.

These are made to be held in either the matching tongs for punches" sold here, or by another pair of tongs that can hold stock thick enough.

• Blacksmithing Punch, Short
• Blacksmithing Punch, Long
• Fullering Punch
• Ball Punch for Blacksmithing, 15 mm
• Swage Punch for Blacksmithing, 6 mm
• Splitting Chisel for Blacksmithing
• Round Hand Punch for Blacksmithing

More details on each tool:

Splitting chisel

Short splitting chisel for blacksmithing, used to make splits and divide material.

Short model made for holding in punch tongs rather than having to hold by hand.

Always use a soft cutting plate to avoid hitting the sharp tool edge into the face of the anvil, like copper or similar.

Swage Punch

Punch for blacksmithing, used to make small holes in material, face is about 6 mm.

Short model made for holding in punch tongs rather than having to hold by hand.

This is basically the same as the "short, round punch" but with a smaller diameter point.

Swage Ball Punch

Punch for blacksmithing, used to make round indents, tabs for bottle openers, dragon eyes etc.

Short model made for holding in punch tongs rather than having to hold by hand.

Makes about a 15 mm indent, about 110 mm long including section for tongs.

Fullering Punch

Punch for blacksmithing, used to make indents and ridges in stock lying flat on the anvil.

Short model made for holding in punch tongs rather than having to hold by hand.

Diameter about 25 mm at the widest, about 120 mm long including section for tongs, fullering face is about 30 mm x 8 mm.

Long, Round Punch for blacksmithing

Punch for blacksmithing, used to make holes when forging.

Long model made for holding in punch tongs rather than having to hold by hand.

Short, Round Punch for blacksmithing

Punch for blacksmithing, used to make holes when forging.

Short model made for holding in punch tongs rather than having to hold by hand.

The punch diameter is about 8mm at the tip and 20mm at the widest point.

Tongs for holding punches

Tongs for holding the short round punches, the fullering punches, swage ball punches and swage split chisel.

The tongs jaws make a ring that loosely hold the tool being punched, these tools are too short to be held by hand.