Corby Bolt 1/4", Brass
- Gift wrapping:
- Options available
Bulk discount rates
Below are the available bulk discount rates for each individual item when you purchase a certain amount
| Buy 4 - 19 | and pay only $2.25 each |
| Buy 20 or above | and pay only $2.00 each |
Description
Corby Bolt, Brass (1/4", 6.35 mm)
Medium size corby bolt in brass, for securing handle scales to full-tang knife blades.
These are often used in addition to epoxy glue, for both looks and additional attachment strength of the handle scales.
The bolt has thicker end pieces (6.35 mm / 1/4") with screwdriver slots in them.
The centre section is 4.6 mm thick and is the part that goes through the blade.
The bolt is threaded, consisting of two pieces that when tighetend is ground down to sit flush with the handle scales.
total length 25 mm
each shoulder 8 mm
middle section 9 mm
screws out to about 13 mm middle section, adding max 4 mm if not screwing them all the way in
Example of corby bolts in Danish made Raffir "Grand Chef" blade, knife by Åge Fjeldberg:
Related Products
Corby Bolt 1/4", Copper
$3.50
Corby Bolt, Copper (1/4", 6.35 mm) Medium size corby bolt in copper, for securing handle scales to full-tang knife blades. These are often used in addition to epoxy glue, for both looks and...
$3.50
Corby Bolt 1/4", Stainless Steel
$3.50
Corby Bolt, Stainless Steel (1/4", 6.5 mm) Medium size corby bolt in steel, for securing handle scales to full-tang knife blades. These are often used in addition to epoxy glue, for both looks and...
$3.50
Corby bolt drill w/counter sink 1/4"
$39.00
Corby Countersink with pilot drill bit, for 1/4" Corby Bolts Made in Germany, set for installing corby bolts of size 1/4" Comes with pilot drill 4.6 mm, and the "countersink" the short stubby drill...
$39.00